Playback Effects - Sharp Viewcam VL-WD450U Operation Manual

Playback Effects
Playback effects can be used to create an
interesting scene transition between a still
image and the following image during play-
back in TAPE-VCR mode.
Type of Playback Effects
OVERLAP: A still image fades out as the next
image fades in, replacing the previous image.
The two scenes momentarily dissolve.
41,
Using Playback Effect
1
In TAPE-VCR mode, press the MENU/
DISPLAY button until the menu screen
appears.
2 Select r-_--1, then press _ on the
Operation button. Select"PB EFFECT"
(_), then press _ (_).
3
Press • or _- / in to select"OVERLAP"
or "WIPE", then press _.
WIPE: A still image is replaced with the next
image first appearing in the middle of the
screen and gradually expanding to fill the
screen.
4
Press the MENU/DISPLAY button to
turn off the menu screen.
5
Rewind or fast forward the tape to just
before the position where you want to
use the playback effect, and then begin
playback.
• The still image is replaced with the next
image with the selected playback effect.
To cancel the playback effect
Select "OFF" in step 3 above.
Preparation
Plan the scene transition, and record still
images with the still recording function (see
page 39).
Notes:
• Playback effects can also be used to provide a
transition from a still image to a moving image.
• Record images for 6 seconds or longer. An
image recorded for less than 6 seconds may not
dissolve properly.
Notes:
• Playback effects will be canceled if Multiple
Strobe Playback is used thereafter.
• Scene transition does not occur if Playback
Zoom or Picture Effect Playback is used
thereafter.
• Playback effects will be canceled if the power
source is interrupted.
62