Safety; General Information And Instructions; Warnings; Intended Use - ABB ProcessMaster FEP611 Operating Instructions Manual

1

Safety

Change from one to two columns
1.1

General information and instructions

These instructions are an important part of the product and
must be retained for future reference.
Installation, commissioning, and maintenance of the product
may only be performed by trained specialist personnel who
have been authorized by the plant operator accordingly. The
specialist personnel must have read and understood the
manual and must comply with its instructions.
For additional information or if specific problems occur that are
not discussed in these instructions, contact the manufacturer.
The content of these instructions is neither part of nor an
amendment to any previous or existing agreement, promise or
legal relationship.
Modifications and repairs to the product may only be
performed if expressly permitted by these instructions.
Information and symbols on the product must be observed.
These may not be removed and must be fully legible at all
times.
The operating company must strictly observe the applicable
national regulations relating to the installation, function testing,
repair and maintenance of electrical products.
1.2

Warnings

The warnings in these instructions are structured as follows:
DANGER
The signal word "DANGER" indicates an imminent danger.
Failure to observe this information will result in death or
severe injury.
WARNING
The signal word "WARNING" indicates an imminent danger.
Failure to observe this information may result in death or
severe injury.
CAUTION
The signal word "CAUTION" indicates an imminent danger.
Failure to observe this information may result in minor or
moderate injury.
NOTE
The signal word "NOTE" indicates useful or important
information about the product.
The signal word "NOTE" is not a signal word indicating a
danger to personnel. The signal word "NOTE" can also refer
to material damage.
Change from two to one column
1.3

Intended use

This device is intended for the following uses:
— To transmit fluid, pulpy or pasty measurement media with
electrical conductivity.
— For volume flow measurement (under operating
conditions).
— For mass flow measurement (based on a fixed density to
be programmed).
The device has been designed for use exclusively within the
technical limit values indicated on the identification plate and
in the data sheets.
In terms of the measuring medium, observe following points:
— Wetted parts such as measuring electrodes, liner,
grounding electrodes, grounding rings, protection flanges
must not be damaged because of the chemical and
physical characteristic of the measuring medium.
— Media with unknown properties or abrasive measuring
media may only be used if regular and suitable tests can
be performed to ensure the safe condition of the device.
— The information on the name plate must be observed.
— Prior to using corrosive and abrasive measurement media,
the operator must check the level of resistance of all parts
coming into contact with the measuring medium.
ABB will gladly support you in selecting the materials, but
cannot accept any liability in doing so.
1.4

Improper use

The following are considered to be instances of improper use
of the device:
— For operating as a flexible adapter in piping, e.g. for
compensating pipe offsets, pipe vibrations, pipe
expansions, etc.
— For use as a climbing aid, e.g. for mounting purposes
— For use as a support for external loads, e.g. as a support
for piping, etc.
— Material application, e.g. by painting over the name plate
or welding/soldering on parts
— Material removal, e.g. by spot drilling the housing
1.5

Warranty provisions

Using the device in a manner that does not fall within the
scope of its intended use, disregarding this manual, using
underqualified personnel, or making unauthorized alterations
releases the manufacturer from liability for any resulting
damage. This renders the manufacturer's warranty null and
void.
ProcessMaster FEP610, HygienicMaster FEH610 | OI/FEP610/FEH610-EN Rev. B 5