Table of Contents
Advertisement
Safety
CAUTION!
This equipment has been tested. It complies with a Field
disturbance sensor device, pursuant to Part 15 of the
FCC Rules and FCC-Gen for IC. Operation is subject to
the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
device generates, uses and radiates radio frequency
energy. If this device is not installed and used in
accordance with the instructions, it can cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation.
NOTE:
This device is certified to measure liquid levels in metal,
concrete or similar materials, enclosed tanks.
NOTE:
The radiated output power of the device is far below the
exposure limits. Nevertheless, use the device in such a
manner that the potential for human contact during
normal operation is minimal.
2.10.1 EN 302372-1, ANNEX B
The following installation requirements shall be fulfilled:
1 SmartRadar FlexLine instruments are required to be installed at
a permanent fixed position at a closed (not open) metallic tank or
reinforced concrete tank, or similar enclosure structure made of
comparable attenuating material.
2 Flanges and attachments of the radar equipment shall provide
the necessary microwave sealing by design.
Part No.: 4417.760_Rev06
SmartRadar FlexLine
Installation Guide
11
Advertisement
Table of Contents
