Grizzly G0750GV Owner's Manual page 50

D
Figure 63. Apron power feed control.
D. Feed Selection Lever: Changes the power
feed to either the cross slide or the carriage.
When the lever is down and the indent pin
is pointing up, the cross slide is selected.
Conversely, when the lever is up and the pin
is pointing down, the carriage is selected.
In the middle position, the apron gears are
disengaged from the feed rod and neither
component will move.
Note: When using this lever, you may need
to slightly rotate the handwheel so that the
apron gears can mesh.
-48-
Setting Power Feed Rate
The feed rate chart (see Figure 62 on previous
page for location) displays the settings for the
headstock feed controls for feed rates.
Examining the chart, you will see a series of
boxes separated by slashes. The top number is
the carriage feed rate, the bottom number is the
cross-slide feed rate, as shown in Figure 64.
Cross-Slide Feed
Rate
Figure 64. Cross slide and carriage feed rates.
Using the controls on the lathe, follow along with
the example below to better understand how to
set the lathe for the desired power feed rate.
Setting Cross-Slide Power Feed Rate of 0.0017
in./rev.
1.
Locate box on feed rate chart that lists 0.0017
in./rev., as shown in Figure 65.
60T Gear
Figure 65. 0.0017 in./rev. location on feed chart.
Model G0750GV (Mfd. Since 03/18)
Carriage Feed
Rate
0.0017 in./rev.