Grizzly G0750GV Owner's Manual page 39

4. Install center in tailstock.
5. Attach lathe dog to test stock from Step 2,
then mount it between centers, as shown
below.
Lathe Dog
Figure 41. Example of stock mounted between
centers.
6.
Turn 0.010" off stock diameter.
7.
Mount test or dial indicator so that plunger is
on tailstock quill.
Note: If necessary in the following step, refer
to the Offsetting Tailstock subsection for
detailed instructions.
8.
Use calipers to measure both ends of work-
piece.
— If test stock is thicker at tailstock end, move
tailstock toward front of lathe
tance of taper amount, as shown below.
Move tailstock toward
front of lathe
Looking down from above.
Figure 42. Adjust tailstock toward the operator.
Model G0750GV (Mfd. Since 03/18)
⁄ the dis-
1
2
/ the
1
2
amount of taper.
— If test stock is thinner at tailstock end,
move tailstock toward back of lathe
distance of taper amount, as shown below.
Looking down from above.
Figure 43. Adjust tailstock away from the
operator.
9. Repeat Steps 6–8 until desired accuracy is
achieved.
⁄
1
2
Move tailstock toward
back of lathe / the
1
2
amount of taper.
-37-
the