Anchoring To Floor - Grizzly G0750GV Owner's Manual

18. For best results, recheck ways in 24 hours
to make sure they are still level and have not
twisted. Re-shim as required.
19. Apply bead of silicone around each base
pedestal where they contact chip tray, to
further reduce possibility of fluids leaking into
cabinets.
20. Install backsplash with (4) M6-1 x 10 cap
screws and (4) 6mm flat washers, as shown
in Figure 19.
x 4
Figure 19. Locations to secure backsplash.
21. Install DRO mounting bracket in pre-threaded
holes on top of headstock using (2) M8-1.25
x 25 cap screws.
22. Attach DRO display unit to DRO mounting
bracket, then connect X-axis and Z-axis sen-
sor wires and power cord to back of DRO
display.
-22-

Anchoring to Floor

Anchoring machinery to the floor prevents tipping
or shifting and reduces vibration that may occur
during operation, resulting in a machine that runs
slightly quieter and feels more solid.
If the machine will be installed in a commercial or
workplace setting, or if it is permanently connect-
ed (hardwired) to the power supply, local codes
may require that it be anchored to the floor.
If not required by any local codes, fastening the
machine to the floor is an optional step. If you
choose not to do this with your machine, we rec-
ommend placing it on machine mounts, as these
provide an easy method for leveling and they have
vibration-absorbing pads.
Anchoring to Concrete Floors
Lag shield anchors with lag screws (see below)
are a popular way to anchor machinery to a con-
crete floor, because the anchors sit flush with the
floor surface, making it easy to unbolt and move
the machine later, if needed. However, anytime
local codes apply, you MUST follow the anchoring
methodology specified by the code.
Machine Base
Concrete
Figure 20. Popular method for anchoring
machinery to a concrete floor.
Model G0750GV (Mfd. Since 03/18)
Lag Screw
Flat Washer
Lag Shield Anchor
Drilled Hole