Log In To Orbi Web Interface - NETGEAR CBK40 User Manual

Installation and basic setup takes about 15 minutes to complete.
To automatically set up your cable modem router:
1. Turn the cable modem router on by pressing the On/Off button.
2. Make sure that your WiFi-enabled computer or mobile device is connected to the cable modem router
with an Ethernet cable (wired) or wirelessly with the preset security settings listed on the label.
Note If you want to change the cable modem router's WiFi settings, use a wired connection
to avoid being disconnected when the new WiFi settings take effect.
3. Launch a web browser.
The page that displays depends on whether you accessed the cable modem router before:
• The first time that you set up the Internet connection for your cable modem router, the browser goes
to orbilogin.com, and the Orbi login page displays.
• If you already set up the Internet connection, enter orbilogin.com in the address field for your
browser to start the installation process.
4. Follow the onscreen instructions.
The cable modem router connects to the Internet.
5. If the browser does not display the web page, do the following:
• Make sure that the computer is connected to one of the four LAN Ethernet ports or over WiFi to the
cable modem router.
• Make sure that the cable modem router is receiving power, and that its Power LED is lit.
• Close and reopen the browser or clear the browser cache.
• Browse to orbilogin.com.
• If the computer is set to a static or fixed IP address (this setting is uncommon), change it to obtain
an IP address automatically from the cable modem router.
6. If the cable modem router does not connect to the Internet, do the following:
a. Review your settings.
b. Make sure that you selected the correct options and typed everything correctly.
c. Contact your ISP to verify that you are using the correct configuration information.
d. Read Troubleshooting
If problems persist, register your NETGEAR product and contact NETGEAR technical support.

Log In to Orbi Web Interface

When you log in to the Orbi, the browser displays the cable modem router web interface. You can use the
cable modem router web interface to change the cable modem router or satellite settings.
Connect to the Network and Access the Cable Modem Router
Orbi WiFi System
on page ?.
20