Labels - NETGEAR CBK40 User Manual

Table 2. Orbi satellite LED descriptions
LED LED Behavior
Power LED The Power LED is located above the Power On/Off button on the rear panel.
• Solid green. Power is on.
• Solid amber. The satellite is booting.
• Blinking amber. The satellite is resetting to factory default settings.
• Blinking red. The firmware is corrupted.
• Off. Power is not supplied.
Ring LED The ring LED is located on the top.
• White. The satellite is attempting to sync with the cable modem router.
• Blue. The cable modem router and satellite successfully synced, and the connection between the cable
modem router is good.
• Amber. The cable modem router and satellite successfully synced, and the connection between the cable
modem router and satellite is fair. Consider moving the satellite closer to the cable modem router.
• Magenta.
The cable modem router and satellite failed to sync. Move the satellite closer to the cable modem router
and try again.
• Off. The satellite synced to the cable modem router and is working normally.

Labels

The cable modem router label shows the admin login information, WiFi network name and password, serial
number, and MAC address.
Figure 3. Cable modem router label
Orbi WiFi System
Hardware Setup
11