Cisco GS7000 Installation And Operation Manual page 42

Chapter 3 Configuration
Note: The title bar indicates which start up mode was used, in this case Add
Device mode.
3 Use the Configuration Wizard toolbar buttons to perform most operations.
Save To
Database
Important: If you are unfamiliar with the Configuration Manager please refer to
Chapter 2 - Working with the Configuration Wizard in the CheetahNet
Administration Guide (Tollgrade part number 6510-30-0357) that was provided with
the CheetahNet software. You can also access the document from the Help menu
within CheetahNet.
Adding the GS7000 Device Using the Configuration Wizard
Perform the following steps to add the GS7000 device.
1 Start the Configuration Wizard.
2 Under Filter Settings in the Category field, click the down arrow and select
FiberNode from the drop-down list.
3 Under Filter Settings in the Type field, click the down arrow and select GS7000.
Note: If the GS7000 device type is not listed then contact the Tollgrade Technical
Assistance department at 888-486-3510 and request the CheetahNet device driver
for the GS7000 Seg2Way device type ID# 8704.
4 Under Filter Settings in the Interface Device field, click the down arrow and
select the associated HEC that will be used to communicate with the GS7000
Seg2Way SM/LCM.
5 Under Filter Settings in the Port field, click the down arrow and select the
associated RF modem port that will be used to communicate with the GS7000
Seg2Way SM/LCM.
6 Under Filter Settings, click the Filter Resource List button.
7 On the Configuration Wizard toolbar, click the Add Resource button.
8 In the Resource List fields, enter the GS7000 Seg2Way SM/LCM device's
Resource Name, Address, RPS Device, and RPS RF Input.
28
Download
Alarm
Config to
Resource
Resource
Refresh
Download
Config to
Resource
Add Copy
Resource
Delete Paste
Resource Resource
Define
Help
Alarm
Topics
Limits
Define
Channel
Plan
4022871 Rev C