Cisco GS7000 Installation And Operation Manual page 39

a Set the minimum and maximum power thresholds for transmitters TX1
through TX4.
Note: The defaults are 0.5 mW minimum and 2.3 mW maximum.
6 Select menu item 5 - Node Settings and enter its sub-menu.
a Set the appropriate settings for your installation. The default settings are as
follows:
AB Switch 1, AB Switch 2: Preferred A
Reverse Port 1, 2, 4, and 5: On, 0 dB
Laser Type: Analog Laser
Forward Seg: Dual
Reverse Seg: Combined
Note: See LCM Configuration Parameters (on page 18) for other setting
options.
Note: Other LCM menu items are not directly related to configuration of the node,
but are primarily read-only status indications. Other menu items of interest are:
Menu item 9 - Restore Defaults, that allows the restoration of the default settings
which is for a fully populated node with two AC lines, two power supplies, four
receivers, and four transmitters installed.
Menu item 9 - Copy Parameters, that allows you to store up to nine node
configuration parameter settings and copy (restore) them to another LCM
located in different node.
4022871 Rev C
Local Control Module Configuration Procedure
25