Cisco GS7000 Installation And Operation Manual page 64

Chapter 5 Using the Web Interface
1 If the GS7000 Configuration Data page is not the active page, click the GS7000
button in the left pane. The GS7000 Configuration Data page appears as shown
in the following example.
2 Set the appropriate configuration options (see table below), and then click the
Apply button. A login dialog appears if the login process had not been
performed previously during the current session.
3 In the login dialog, enter the correct user name and password, and then click
OK.
The following table lists the configuration options available on the GS7000
Configuration Data page.
Component
Node Type
Forward Configuration
48
Description
Sets the GS7000 device type to one of the following:

deviceGS7000

deviceGS7000opticalHubNode
The forward configuration of the node.

oneX/twoXFwdSeg - Forward RF signal for all ports
comes from one or two optical receivers.

fourXFwdSeg - Forward RF signal for each port comes
from separate optical receivers.

threeXRx1-2-4FwdSeg - Forward RF signal for each port
comes from one of three separate optical receivers. The
three receivers are Rx1, 2 and 4; Rx3 is not powered on.

threeXRx1-3-4FwdSeg - Forward RF signal for each port
comes from one of three separate optical receivers. The
three receivers are Rx1, 3 and 4; Rx2 is not powered on.
4037424 Rev A