Gs7000 Configuration Data Page - Cisco GS7000 Installation And Operation Manual

The Device combo box displays the different devices and network configurations the
transponder can be configured to operate within. The device that is displayed
without the box extended is the device the transponder is configured for. Choosing
the appropriate device type is necessary to ensure the device is properly controlled
and monitored. The available options are the following:
Cisco GS7000

Cisco GS7000 Dual IP

To change the device:
1 Select the appropriate device type, and then click the Apply button. A login
dialog appears if the login process had not been performed previously during
the current session.
2 In the login dialog, enter the correct user name and password, and then click
OK.

GS7000 Configuration Data Page

Before the transponder can monitor the node it will need to be set up for how the
node is configured. For the GS7000 Node, this can be accomplished by using either
the SA-HMS-FIBERNODEGS7000-MIB or through the GS7000 Configuration Data
page. For the GS7000 Optical Hub, this can only be accomplished through the
GS7000 Configuration Data page.
This section describes how to configure the transponder through the GS7000
Configuration Data page. For information on how to configure the transponder by
using the SA-HMS-FIBERNODEGS7000-MIB, see Configuring the Transponder
Using the SA-HMS-FIBERNODEGS7000 MIB (on page 21).
4037424 Rev A
Configuration Pages
47