Telnet Access Matrix - Cisco GS7000 Installation And Operation Manual

Telnet Access Matrix

The following table provides a matrix describing the settings of the different access
options. Change these values as deemed necessary.
telnetServerControl
OID Value
0
1
1
1
1
Complete the following steps to access the transponder locally using the console via
a Telnet connection.
1 Be certain that Telnet access to the server has been enabled by making the
appropriate MIB changes. Refer to the information presented earlier in this
section for details on enabling Telnet access to the server.
2 Verify that software capable of supporting a standard Telnet communications
session is present and operational on the laptop or similar device being used to
communicate with the transponder.
3 Connect a standard CAT5 Ethernet cable between the transponder and a laptop
or similar device.
4 Using your Telnet client software and IP address 192.168.100.1, establish a Telnet
session to the transponder. The console main page appears as shown in the
following example.
4037424 Rev A
telnetIpStackInterfaces
OID Value
0x00
0x00
0x40
0x80
0xC0
Result
Telnet access is disabled and both
interfaces are disabled.
Telnet access is enabled and both
interfaces are disabled.
Telnet access is enabled, the CM
interface is disabled, and the Craft
port interface is enabled.
Telnet access is enabled, the CM
interface is enabled, and the Craft
port interface is disabled.
Telnet access is enabled, the CM
interface is enabled, and the Craft
port interface is enabled.
Console Access
39