Cisco GS7000 Installation And Operation Manual page 56

Chapter 4 Using the Craft Port
Note: If you have difficulty establishing communications with the transponder,
try changing the laptop IP address value to 192.168.100.2 and its subnet mask
value to 255.255.255.0.
5 Press the Enter key. At the login prompt, enter the appropriate user name (the
default is cheetah) and press the Enter key. Next, enter the appropriate password
(the default is cheetah) and press the Enter key. The console prompt page
appears as shown in the following example.
6 Console mode supports a number of commands that are used for
troubleshooting and debugging purposes. Providing a list and description of all
of the available commands would exceed the scope of this manual. Therefore, the
commands described in this section will be those found in the hms directory. For
additional information about the use of the console commands, contact Technical
Support using the contact information provided in Customer Support
Information (on page 79).
The following table provides a list of the commands in the hms section available via
console mode along with a brief description of each command.
Command
devices
dumps
images
rawio
smio
spidump
spistats
status
40
Description
Displays the modules that have been discovered in the Fiber Node.
Toggles the serial dump feature on and off.
Displays the firmware image information.
Displays the raw input and output values from the transponder's two
processors.
Displays the status monitoring IO values.
Toggles the spidump feature on and off.
Displays the SPI statistics.
Displays general transponder information, i.e., firmware version, IP
addresses, etc.
4037424 Rev A