Installing the Transponder
This section provides information for installing the transponder in the following
devices:
GS7000 Node
GS7000 Optical Hub
Refer to the appropriate section for installing the transponder in your particular
hardware.
GS7000 Node Installation
Complete the following steps to install the transponder in the GS7000 Node.
1
Remove the transponder from the shipping package.
2
Ensure that the correct pad for the desired application is installed in the pad
socket. For GS7000 Node applications, verify the use of the 0 dB pad in the
transponder pad socket, as shown below.
3
If any other pad value is in place (a 10 dB pad, for example), replace it with the 0
dB pad as shown below.
4037424 Rev A
Installing the Transponder
13