Inventory - Grizzly G0796 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Small Item Inventory (Figure 8)
A. Front Way Cover ......................................... 1
B. Fine Downfeed Handwheel ........................ 1
C. Rear Way Cover ......................................... 1
D. Drawbar ...................................................... 1
E. Knee Crank ................................................ 1
F.
Belt Housing Safety Covers (G0796) ......... 2
G. Revolving Handles ..................................... 3
H. Coarse Downfeed Lever ............................. 1
I.
Ball Handles ............................................... 3
J.
Closed-End Wrench 17/19mm .................... 1
K. Hex Wrench Set 4, 5, 6, 8MM ...............1 Ea
L. Phillips Screwdriver #2 ............................... 1
M. Slotted Screwdriver #2 ............................... 1
N. Bottle for Oil ............................................... 1
O. Toolbox ....................................................... 1
Model G0796/G0797 (Mfd. Since 1/18)
A
D
G
I
L
M
Qty
Figure 8. Small item inventory.
B
E
H
J
O
N
C
F
K
-19-