Power Connection - Grizzly G0796 Owner's Manual

5. Move table all the way back toward the
column, then attach front way cover with
five pre-installed cap screws, as shown in
Figure 18.
Figure 18. Front way cover installed.
6. Install coarse downfeed lever (see Figure 19),
making sure pin on back of lever seats in
hub, then use a 4mm hex wrench to tighten
set screw.
7. Use a Phillips head screwdriver to remove
auto-downfeed direction pin from hub, then
mount fine downfeed handwheel on hub,
making sure pin on back of handwheel seats
in hub, and secure with auto-downfeed direc-
tion pin (see Figure 19).
Fine Downfeed
Handwheel
Auto-Downfeed
Direction Pin
Figure 19. Downfeed controls installed.
Model G0796/G0797 (Mfd. Since 1/18)
Cap
Screws
Coarse
Downfeed Lever
Set
Screw

Power Connection

Electrocution
may occur if machine is
ungrounded,
connected to power, or
connected to an undersized
circuit. Use an electrician
or
personnel to ensure a safe
power connection.
Before the machine can be connected to the
power source, an electrical circuit and connec-
tion device must be prepared per the POWER
SUPPLY section in this manual, and all previ-
ous setup instructions in this manual must be
complete to ensure that the machine has been
assembled and installed properly.
Always make sure the power switch on the
machine is turned OFF (or the OFF button is
pushed in) before connecting power.
Power Connection
Insert power cord plug into a matching power sup-
ply receptacle. The machine is now connected to
the power source.
If you need to disconnect the machine from power
later, pull the plug completely out of the recep-
tacle.
Note About Extension Cords: Using an incor-
rectly sized extension cord may decrease the
life of electrical components on your machine.
Refer to Extension Cords on Page 17 for more
information.
or fire
incorrectly
a qualified service
-25-