Unloading Tooling - Grizzly G0796 Owner's Manual

5. With one hand holding tool in place, insert
drawbar into spindle from top of head, then
thread it into tool by hand until snug (see
Figure 48).
Figure 48. Drawbar loaded
(Model G0796 shown).
6.
Use 19mm wrench to tighten drawbar an
additional ⁄ turn.
1
4
Note: Do not
Overtightening makes tool removal difficult
and may damage arbor and threads.
-42-
overtighten drawbar.

Unloading Tooling

1.
DISCONNECT MACHINE FROM POWER!
2.
Place mill in low spindle speed range to keep
spindle from turning during next step.
3. Loosen drawbar one full rotation.
Note: Make sure that the drawbar has at
least three threads engaged with the tooling,
or the drawbar and tool threads could be
damaged in the next step.
4.
Tap top of drawbar with hammer to unseat
taper (see Figure 49).
Figure 49. Tapping drawbar to unseat tool taper
(G0796 shown).
5.
Support tool with one hand and fully unthread
drawbar from tool.
Model G0796/G0797 (Mfd. Since 1/18)