Ram Ways - Grizzly G0796 Owner's Manual

Table Ways (One-Shot Oiler)
Oil Type ..... Model SB1365 or ISO 68 Equivalent
Oil Amount .................. One Pull of Pump Handle
Check/Add Frequency ...... 4–8 Hrs. of Operation
The one-shot oiler is connected to a series of
aluminum tubes that carry the lubricant to wear
points along the table horizontal and vertical ways.
Pull the handle out slowly then release it to send
the oil through the tubes (see Figure 66), then
move the table through all paths of movement to
evenly distribute the lubricant.
Use the sight glass on the side of the oiler to know
when to re-fill the reservoir. The reservoir capacity
is ⁄ liter.
1
2
Reservoir Cap
Pump
Handle
Figure 66. One-shot oiler components.
Headstock Gearing (G0797)
Grease Type .....................NLGI #2 or Equivalent
Grease Amount ........Two Pumps of Grease Gun
Check/Add Frequency .........40 Hrs. of Operation
Add two pumps from a grease gun to the grease
fitting shown in Figure 67.
Figure 67. Model G0797 headstock gearing
grease fitting.
-48-

Ram Ways

Oil Type ..... Model SB1365 or ISO 68 Equivalent
Oil Amount ............................................Thin Coat
Check/Add Frequency .........40 Hrs. of Operation
Move the ram back and forth as necessary to
access the full length of the ways (see Figure 68),
then use a clean shop rag to apply a thin coat of
lubricant to the ways.
Head Tilt & Ram Pinions
The interaction between the cast iron surfaces
of these devices (see Figure 69) produces a dry
Sight Glass
powder that provides an adequate lubrication.
Do not apply any other lubricant because it could
produce a stiff compound, which may interfere
with smooth movement.
Ram Ways
Figure 68. Ram ways.
Head Tilt
Rack & Pinion Gear
Figure 69. Head tilt and ram pinions.
Model G0796/G0797 (Mfd. Since 1/18)
Ram
Pinion Gear