Inventory - Grizzly G0799 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
After all the parts have been removed from the
shipping containers, you should have the follow-
ing items:
Inventory (Figures 7–10):
A. Lathe Assembly
—Headstock (mounted) ............................. 1
—Tool Rest (mounted) ................................ 1
—Tool Rest Base (mounted) ...................... 1
—Tailstock (mounted) ................................. 1
Figure 7. Lathe assembly.
-18-
Qty
A
B. Stand Legs ................................................. 2
C. Open-End Wrench 50mm .......................... 1
D. Faceplate 3" ............................................... 1
—Set Screws M6-1 x 10 ............................. 2
E. Tool Rack .................................................. 1
F.
Live Center ................................................ 1
G. Knockout Rod ............................................ 1
H. Hex Wrenches 3, 10mm ........................1 Ea
I.
Machine Feet w/Hex Nuts ......................... 4
J.
Locating Rod .............................................. 1
K. Live Center Pin ........................................... 1
L. Spur Center ............................................... 1
Figure 8. Stand legs.
C
H
I
L
G
Figure 9. Loose inventory components.
Model G0799 G0800 (Mfd. Since 09/15)
B
D
E
J
F
K