Grizzly G0799 Owner's Manual page 27

20. Use (2) M12-1.75 x 20 cap screws, (2)
12mm flat washers, and (2) 12mm lock
washers to install tool rack at end of lathe bed
(see Figure 23).
Tool Rack
Figure 23. Tool rack mounted at end of bed.
Note: The tool rack can also be installed on
the front of the lathe bed (see Figure 24)
using the same fasteners listed above.
x 2
Figure 24. Tool rest mounted on front of bed.
Model G0799 G0800 (Mfd. Since 09/15)
21. Locate pre-installed lower hinge, hinge pin,
x 2
Tool
Rack
and brass washer (see Figure 25) at end of
lathe bed. Mount swing-away bed by lower-
ing upper hinge onto hinge pin (see Figure
26). Leave M6-1 x 10 set screws loose for
now.
Hinge Pin
Brass
Washer
Lower
Hinge
Figure 25. Lower hinge, hinge pin, and brass
washer for mounting swing-away bed.
Swing-Away Bed
Hinge Pin
Upper
Hinge
Figure 26. Swing-away bed hinge assembled.
Lathe Bed
Set Screws
-25-