Attach The Brackets To The Sce 1000 - Cisco SCE 1000 Quick Start Manual

Attach the Brackets to the SCE 1000

Before installing the SCE 1000 in the rack, you must first install an appropriate rack-mount bracket on each side of the front
of the SCE 1000, as illustrated in the following figures.
Figure 4 Attaching the Mounting Brackets (4-post)
PW R A
PW R B
STA TUS
BYP ASS
MN G 1
MN G 2
CO NSO LE
LINK / AU X LINK RX
10/1 00/ TX
ACT IVE
1000 LINK / 10/1 00/
ACT IVE
1000
RX
MM
TX
GBE -1
SUB
LINE
Figure 5 Attaching the Mounting Brackets (2-post)
PW R A
PW R B
MN G 1
MN G 2
CO NS OL
E
AU X
LIN K/
10/ 100 /
AC TIV E
LIN K/
100 0 10/ 100 /
AC TIV E
100 0
To install the rack-mount brackets on the SCE 1000 chassis, complete the following steps:
Before installing the SCE 1000 in the rack, you must first install a rack-mount bracket on each side of the front of the SCE 1000.
Align the rack-mount bracket to the side of the SCE 1000. Choose the proper bracket for your installation (2-post rack
Step 1
or 4-post rack) as illustrated in Rack-Mount the SCE 1000
Step 2 Insert and tighten three screws.
Repeat steps 1 and 2 on the other side of the SCE 1000.
Step 3
If mounting the SCE 1000 in a rack with only two posts, skip to Mount the System to the Rack.
If mounting the SCE 1000 in a rack with four posts, proceed to the next step, Installing the Crossrail Supports
(Four-post rack only), page 6).
C is co S
C E 10 00
Se rie s
2x G B E
LINK RX
TX
RX
MM
TX
NET
ST AT US
BY PA SS
C is c o S
C E 1 0 0 0
S er ie s
LIN K RX 2 x G B E
TX
LIN K RX
TX
RX
MM
TX
RX
MM
TX
GB E-1
SU B
LIN E
NE T
1 2
1 2
5