Cisco SCE 1000 Quick Start Manual page 28

Configure additional SET communities.
Step 6
a. To add more entries, do not accept the default:
Would you like to add another SNMP SET community? [no]:
Type y and press Enter.
b. Enter up to 20 SNMP SET communities as described in step 5.
c. When all entries have been added, accept the default:
Would you like to add another SNMP SET community? [no]:
Press Enter to accept.
Step 7 Configure the SNMP trap managers.
a. Enter the SNMP trap managers menu.
Would you like to configure SNMP trap managers? [no]: y
Type y and press Enter.
The SNMP trap managers dialog begins.
If you choose not to configure SNMP trap managers, the dialog skips to the authentication failure trap status. (See
step 9.)
b. Configure the trap manager IP address
Enter SNMP trap manager IP address:
Type the trap manager community string and press Enter.
Note that there is no default for this parameter.
c. Configure the trap manager community string
Enter SNMP trap manager community string:
Type the trap manager community string and press Enter.
Note that there is no default for this parameter.
d. Configure the trap manager SNMP version.
Enter trap manager SNMP version:
Type the number of the trap manager SNMP version (1 or 2c) and press Enter.
Note that there is no default for this parameter.
Configure additional trap managers.
Step 8
The maximum number of trap managers is 20.
a. To add more entries do not accept the default:
Would you like to add another SNMP trap manager? [no]:
Type y and press Enter.
b. Enter up to 20 trap managers as described in step 7.
c. When all entries have been added, accept the default:
Would you like to add another SNMP trap manager? [no]:
Press Enter to accept.
Step 9 Configure the Authentication Failure trap status.
To disable the Authentication Failure trap, press Enter.
–
To enable the Authentication Failure trap, type y and press Enter.
–
Enable the 'Authentication Failure' trap [no]:
28