Connect The Management Interface - Cisco SCE 1000 Quick Start Manual

Example 3:
Following is an example of a configuration that was aborted, although no errors were detected.
Data collection for the system configuration is completed.
Would you like to view the new configuration before it is applied? [yes/no]:
Apply and Save this configuration? [yes/no]: n
The changes you have just entered would be discarded, are you sure? [yes/no]:y
Setup procedure aborted, no configuration changes made.

Connect the Management Interface

Figure 15 Cabling the Management Port
MN G 1
MN G 2
CO NS OL
E
LIN K/
10/1 00/
ACT IVE
LIN K/
100 0 10/1 00/
ACT IVE
100 0
3
1 2
By default, the management port is configured to auto-negotiation enabled.
Note
The SCE 1000 has two management ports, labeled Mng1 and Mng 2. Use the Mng 1 port.
Plug the Ethernet cable provided (with attached RJ-45 connector) into the Mng 1 port on the front panel of the
Step 1
SCE 1000.
Step 2 Connect the other end of the Ethernet cable into your management network.
The Link LED on the SCE 1000 management port should light up.
Test connectivity. From the host that you intend to use for remote management, ping to the SCE 1000 by typing ping
Step 3
and the SCE 1000 IP address, and pressing Enter (see the example, below).
This verifies that an active connection exists between the specified station and the management port.
Example:
The following example displays a typical ping response where the target IP address is 10.1.1.201.
C:\>ping 10.1.1.201
pinging 10.1.1.201...
PING 10.1.1.201: 56 data bytes
64 bytes from host (10.1.1.201): icmp_seq=0. time=0. ms
64 bytes from host (10.1.1.201): icmp_seq=1. time=0. ms
64 bytes from host (10.1.1.201): icmp_seq=2. time=0. ms
64 bytes from host (10.1.1.201): icmp_seq=3. time=0. ms
----10.1.1.201 PING Statistics----
4 packets transmitted, 4 packets received, 0% packet loss
round-trip (ms) min/avg/max = 0/0/0
34
PW R A
PW R B
STA TU S
BY PAS S
C is co S
LIN K RX
AU X 4 xG B E
TX
LIN K RX
TX
LIN K RX
TX
RX
MM
TX
RX
MM
TX
RX
MM
TX
RX
GB E-1
SU B
LIN E
NE T
GB E-2
SU B LIN
E/C AS CA
DE NE T
C E 2 0 0 0
Se rie s
LIN K RX
TX
MM
TX