Step 10: Completing And Saving The Configuration - Cisco SCE 1000 Quick Start Manual

Example 2:
Following is a sample topology configuration for a non-redundant bump-in-the-wire (inline) topology. All values are the system
default values, so it is not necessary to type in the response. Simply press enter at each line.
• Connection mode — Inline
• For a non-redundant topology, link bypass on-failure should be Bypass, so that traffic continues to flow through the link.
• After operation of the system resumes, and the SCE 1000 reboots, the SCE 1000 will resume operation. (Admin status after
abnormal reboot is Operational.)
Would you like to enter the Topology configuration menu? [no]: y
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]:
Enter On-failure behavior:
1- Bypass
2- Cutoff
Enter your choice [1]:
Enter admin status of the SCe after abnormal boot:
1- Operational
2- Not-Operational
Enter your choice [1]:
Data collection for the system configuration is completed.
Example 3:
Following is a sample topology configuration for a redundant inline topology.
• Connection mode — Inline
• For a redundant topology, link bypass on-failure should be Cutoff, so that operation switches to the backup link.
• After operation of the system resumes, and the SCE 1000 reboots, the SCE 1000 will resume operation. (Admin status after
abnormal reboot is Operational.)
Would you like to enter the Topology configuration menu? [no]: y
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]: 2
Enter On-failure behavior:
1- Bypass
2- Cutoff
Enter your choice [1]:2
Enter admin status of the SCE after abnormal boot:
1- Operational
2- Not-Operational
Enter your choice [1]:
Data collection for the system configuration is completed.

Step 10: Completing and Saving the Configuration

When you have completed the entire configuration, the system checks for errors. If errors are found, a warning message appears.
When the configuration is error-free, you may apply and save it.
31