Measurement & Annotation Setup - GE Mentor Visual iQ User Manual

07/30/2014
Measurement & Annotation Setup
1
– Tap the lower-left corner of the display (typically contains a GE Logo) or (or press
the hard key) at any time to open the Global Menu, which provides access to
the Setup Menu.
2
– Select to alter the Measurement and Annotation-specific settings shown here.
3
– View the list of 3DPM Tips already calibrated for use with the attached probe.
4
– Select to view a list of Stereo Tips already-calibrated for use with the attached
probe. The Add Tip and Edit List options are not intended for general use. Deleting
a tip through the Edit List option will permanently remove that tip's calibration data
requiring the probe and tip to be returned to an authorized GE Inspection Technologies
service center for re-calibration.
5
– Save Preset Annotation (notes) to an external storage device or Import preset notes
to the instrument from an external device.
6
– Displays or removes the Zoom Window (used for detailed cursor placement during
measurement).
7
– Select AUTO to show the 3DPM red/yellow un-measurable pixel mask only when a
cursor is placed on a red/yellow pixel. Select ON to always show the pixel mask when
measuring.
8
– Select Z-Map for most usage. P-Map images contain additional data and may be
requested by GE Technical Support to aid in troubleshooting.
9
– Controls the display of the Stereo Index, which appears during Stereo Measurement.
Click here for more about Stereo Index.
10
– Sets a threshold value for the Stereo Index below which the index flashes during
Stereo Measurement. This may be used to warn the user of low-index measurements
where the accuracy may be reduced.
11
– Specify the unit of measurement as Inches or Millimeters.
25