About The Battery - GE Mentor Visual iQ User Manual

About the Battery

The Visual iQ is powered by a 10.8 V (nominal), 73 Wh, 6.8 Ah Lithium Ion battery.
Installing the Battery
Insert the battery into the handset. The battery is installed properly when the latching
mechanism is engaged.
Caution—Do not force the battery (
The battery is keyed and may only be installed in the proper orientation.
Removing the Battery
3
Press battery release button ( ) to release the battery.
Caution—Do not remove the battery while the system is operating.
Battery Charge Level
Check the battery charge by pressing the battery symbol (
5
Each light ( ) represents approximately 20% of the battery charge capacity.
Charging the Battery
Connect the DC output of the battery charger into the Visual iQ battery (
plug the included AC to DC power adaptor into a suitable AC power source. The LED
battery lights will illuminate according to the amount of charge attained. The system
may operate while charging.
Note: The battery may be charged while connected to an operating Visual iQ or while
disconnected from the iQ.
Note: When the battery is fully charged, the LED battery lights will turn off.
Note: Battery run time approximately equals battery charge time; therefore, a two hour
battery will take approximately two hours to charge. Charging time will be longer if the
battery is connected to an operating Visual iQ system while charging.
Note: All batteries are shipped with a partial charge. Batteries should be fully charged
prior to use.
14
1 2
) into the handset ( ), as damage may occur.
4
) on the front of the battery.
6
) and then
07/30/2014