Casio QT-7300 Service Manual page 35

4-17-4. Setup and Diagnostic Test
Following software are provided in the Ethernet RTL8139 Drivers (Disk 3) floppy disk for setup and test the
Ethernet system.
Run RSET8139.EXE, a list of options including "View Current Configuration", "Set Up New Configuration",
"Run Diagnostic" and "Exit RSET8139" will appear.
NOTE: You should run this software under dos mode.
4-17-4-1. Configuration
View Current Configuration
View Current Configuration is an information display. It shows your PCI LAN board current configuration.
Set Up New Configuration
Set Up New configuration gives you complete control over the configuration of the LAN board. It lets you
set up the board in the computer while specifying parameters for a different computer. You can designate
the Node ID, the Manufacture's ID, Full-duplex mode, the BROM size and Flow control. Changing I/O base
and Interrupt in PCI system is not allowed.
4-17-4-2. Diagnostic Test
Run Diagnostic
Run Diagnostic lets you verify that your LAN Board is working correctly, a list of options including "Run
EEPROM Test", "Run Diagnostic On Board", "Run Diagnostic On network" and "Run Power Management
test".
— 33 —