Casio QT-7300 Service Manual page 25

• HDD Power Down < Disabled >
After the selected period of drive inactivity (1 to 15 minute), the hard disk drive powers down while all
other devices remain active.
• Throttle Duty Cycle < 62.5% >
When the system enters Doze mode, the CPU clock runs only part of the time. You must select the
percent of time that the clock runs.
• PCI/VGA Act-Monitor < Disabled >
When Enabled, any vide activity restarts the global timer for Standby mode.
• Soft-Off by PWR-BTTN < Instant-Off >
This only works with system using an ATX power supply. It also allows user to define the type of soft
power OFF sequence the system will follow.
• Wake Up on LAN < Enabled >
All input signal on the network awakens the system from a soft-off state.
• IRQ 8 Break Suspend < Disabled >
You can turn on or off monitoring of IRQ8 (the Real Time Clock) so it does not awaken the system form
Suspend mode.
** Reload Global Timer Events **
When Enabled, an event occurring on each device listed below restarts the global time for Stanby
mode.
• IRQ[3-7,9-15],NMI < Disabled >
• Primary IDE 0 < Disabled >
• Primary IDE 1 < Disabled >
Secondary IDE 0 < Disabled >
•
Secondary IDE 1 < Disabled >
•
NOTE: Secondary drives are not support.
Floppy Disk < Disabled >
•
• Serial Port < Enabled >
• Parallel Port < Disabled >
— 23 —