Video Presentation Defaultsource; Video Selfview Default Fullscreenmode; Video Selfview Default Mode; Video Selfview Default Onmonitorrole - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction

Video Presentation DefaultSource

Define which video input source to use as a default presentation source. This setting may
be used by the API and 3rd party user interfaces. It is not relevant when using the user
interfaces provided by Cisco.
Requires user role: ADMIN, USER
Default value: 3
Value space: 1/2/3/4
The video input source to use as default presentation source.

Video Selfview Default Mode

Define if the main video source (self-view) shall be displayed on screen after a call. The
position and size of the self-view window is determined by the Video Selfview Default
PIPPosition and the Video Selfview Default FullscreenMode settings respectively.
Requires user role: ADMIN, INTEGRATOR
Default value: Current
Value space: Off/Current/On
Off: self-view is switched off when leaving a call.
Current: self-view is left as is, i.e. if it was on during the call, it remains on after the call; if
it was off during the call, it remains off after the call.
On: self-view is switched on when leaving a call.
D15328.07 SX80 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals Maintenance

Video Selfview Default FullscreenMode

Define if the main video source (self-view) shall be shown in full screen or as a small
picture-in-picture (PiP) after a call. The setting only takes effect when self-view is switched
on (see the Video Selfview Default Mode setting).
Requires user role: ADMIN, INTEGRATOR
Default value: Current
Value space: Off/Current/On
Off: self-view will be shown as a PiP.
Current: The size of the self-view picture will be kept unchanged when leaving a call, i.e.
if it was a PiP during the call, it remains a PiP after the call; if it was fullscreen during the
call, it remains fullscreen after the call.
On: The self-view picture will be shown in fullscreen.

Video Selfview Default OnMonitorRole

Define which monitor/output to display the main video source (self-view) on after a call. The
value reflects the monitor roles set for the different outputs in the Video Output Connector
[n] MonitorRole setting.
The setting applies both when self-view is displayed in full screen, and when it is displayed
as picture-in-picture (PiP), but only if the Video Monitors setting is set to Dual or Triple.
Requires user role: ADMIN, INTEGRATOR
Default value: Current
Value space: First/Second/Third/Current
First: The self-view picture will be shown on outputs with the Video Output Connector [n]
MonitorRole set to First.
Second: The self-view picture will be shown on outputs with the Video Output
Connector [n] MonitorRole set to Second.
Third: The self-view picture will be shown on outputs with the Video Output Connector
[n] MonitorRole set to Third.
Current: When leaving a call, the self-view picture will be kept on the same output as it
was during the call.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
152
Administrator Guide
System settings System settings Appendices