Cisco TelePresence SX80 Administrator's Manual page 73

Cisco TelePresence SX80

Introduction
Factory reset the video system
Factory reset using the shutdown button
We recommend that you back up the log files and configuration of
the video system before you continue with the factory reset.
1. Press and hold the shutdown button until the LEDs go out
(approximately 5 sec) and the system shuts down.
2. Press and hold the shutdown button until the power LED start
blinking (approximately 10 seconds). Then release the button.
3. Within four seconds after the LED starts blinking, press the
shutdown button twice to engage the factory reset.
4. Wait while the video system reverts to the default factory
settings. When finished, the video system restarts
automatically. This may take a few minutes.
When the system has been successfully reset to factory
settings, the Setup assistant starts with the Welcome screen.
If you failed to press the shutdown button twice within
the four seconds, the system will not revert to the default
factory settings, and you will not see the confirmation
message. If this happens, go back to step 1 and try again.
D15328.07 SX80 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals
(page 3 of 3)
Shutdown
button
Maintenance Maintenance
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
73
Administrator Guide
System settings Appendices