Video Monitors; Video Output Connector [1..2] Cec Mode - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction

Video Monitors

A role is assigned to each monitor using the Video Output Connector [n] MonitorRole
setting. The monitor role decides which layout (call participants and presentation) will
appear on the monitor that is connected to this output. Monitors with the same monitor role
will get the same layout; monitors with different monitor roles will have different layouts.
The monitor layout mode that is set in the Video Monitors setting should reflect the number
of different layouts you want in your room setup. Note that some monitors can be reserved
for presentations.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
Value space: Auto/Single/Dual/DualPresentationOnly/TriplePresentationOnly/Triple
Auto: The number of monitors connected to the codec is automatically detected, and the
layout is distributed on the monitors according to the MonitorRole settings.
Single: The same layout is shown on all monitors.
Dual: The layout is distributed on monitors with monitor role First and Second. If a
presentation is part of the layout, all participants in the call are shown on monitors with
monitor role First, and the presentation is shown on monitors with monitor role Second.
DualPresentationOnly: All participants in the call are shown on monitors with monitor role
First. If a presentation is part of the layout, the presentation is shown on monitors with
monitor role Second.
Triple: The layout is distributed on monitors with monitor role First, Second and Third.
Monitors with monitor role Second are used first, then First, and finally Third. If a
presentation is part of the layout, all participants in the call are shown on monitors
with monitor role First and Second, and the presentation is shown on the monitor with
monitor role Third.
TriplePresentationOnly: All participants in the call are distributed on monitors with
monitor role First and Second. Monitors with monitor role Second are used first, then
First. If a presentation is part of the layout, the presentation is shown on the monitor with
monitor role Third.
D15328.07 SX80 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals Maintenance

Video Output Connector [1..2] CEC Mode

This video output (HDMI) supports Consumer Electronics Control (CEC). When this setting
is On, the system will use CEC to set the monitor in standby when the system itself enters
standby. Likewise the system will wake up the monitor when the system itself wakes up
from standby. For this to happen, the monitor that is connected to the output must be CEC
compatible and CEC must be configured on the monitor.
Note that the different manufacturers uses different marketing names for CEC, for example
Anynet+ (Samsung); Aquos Link (Sharp); BRAVIA Sync (Sony); HDMI-CEC (Hitachi); Kuro
Link (Pioneer); CE-Link and Regza Link (Toshiba); RIHD (Onkyo); HDAVI Control, EZ-Sync,
VIERA Link (Panasonic); EasyLink (Philips); and NetCommand for HDMI (Mitsubishi).
Requires user role: ADMIN, INTEGRATOR
Default value: Off
Value space: Off/On
Off: CEC is disabled.
On: CEC is enabled.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
149
Administrator Guide
System settings System settings Appendices