Cisco TelePresence SX80 Administrator's Manual page 43

Cisco TelePresence SX80

Introduction
Connect monitors
(page 2 of 2)
Manual setup
The automatic setup works well for common single monitor,
dual monitors, and triple monitors scenarios. For more complex
scenarios, you may need manual configuration.
Sign in to the web interface and navigate to
to find the settings referred below.
Set a role for each Set the number of
monitor monitors
Define a role for each monitor Set the number of monitors
with the Video > Output > with different layouts in
Connector n > MonitorRole your setup with the
setting. Monitors
Choose monitor roles that When set to Auto, the video
match your monitor setup. system automatically detects
if a monitor is connected to a
connector, and thereby also
determines the number of
monitors in the setup.
The other options allow you
to fix a single, dual, or triple
monitor setup; and to dedicate
one monitor for presentations.
Example 1:
Three monitors in total, and the third monitor is dedicated to only
show presentations:
• Video > Monitors: TriplePresentationOnly
• Video > Output > Connector 1 > MonitorRole: Auto
• Video > Output > Connector 2 > MonitorRole: Auto
• Video > Output > Connector 3 > MonitorRole: Auto
• UserInterface > OSD > Output: Auto
D15328.07 SX80 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals Peripherals
Setup > Configuration,
Choose on which
monitor to display
messages and indicators
Define on which monitor to
Video >
display the messages and
setting.
indicators on-screen with the
UserInterface > OSD > Output
setting.
When set to Auto, the video
system determines which
monitor to use based on the
number of the connector.
Example 2:
Two monitors in total, and a recording device is attached to
Connector 3 (DVI). OSD on the monitor on Connector 2:
• Video >
• Video > Output > Connector 1 >
• Video > Output > Connector 2 >
• Video > Output > Connector 3 >
• UserInterface > OSD >
Maintenance
Set the monitor
resolution and refresh
rate
The video system reads the
native resolution of a monitor
and outputs this if possible.
Typically, this gives the best
possible picture for the
monitor.
If auto-detection of resolution
and refresh rate fails, you must
set the resolution manually
with the Video > Output >
Connector n > Resolution
setting.
Monitors: Auto
MonitorRole: Auto
MonitorRole: Auto
MonitorRole: Recorder
Output: 2
43
Administrator Guide
System settings
About the number of
monitors and the role of
each monitor
The Video > Output > Connector n >
MonitorRole setting assigns a role to the
monitor that is connected to the output.
The monitor role decide which layout (call
participants and presentation) will appear
on the monitor.
Monitors with the same monitor role get
the same layout; monitors with different
monitor roles get different layouts.
The Video > Monitors
the number of different layouts in your
room setup.
Most often the number of different
layouts are the same as the number
of physical monitors, but not always. If
exactly the same layout shall be repeated
on two or more monitors, the number of
different layouts is less.
Note that a monitor can be reserved for
presentations.
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
Appendices
setting must reflect