Toro Power Max Service Manual page 79

3. Clamp or hold gear and turn it over to properly install
the 3 pawl supports and torx screws (Fig. 192).
4. Torque the T-27 torx screws to 100 to 125 in-lbs.
(11.3 to 14.1 Nm) (Fig. 193).
Power Max Service Manual
TRACTION DRIVE SYSTEM
Fig 192
MVC-904X.jpg
Fig 193
MVC-905XWC.jpg
WHEEL CLUTCH
5. Install the 4 guide collars to shaft with shift brace
plate (Fig. 194).
6. Torque the screws no more then 50 - 70 in-lbs. (5.65
– 7.9 Nm).
7. Slide fl at washers next to guides (Fig. 195).
Fig 194
MVC-1909X.jpg
Fig 195
MVC-1911X.jpg
9-21