Primer Button; Ignition Switch - Toro Power Max Service Manual

ENGINE
3. Pull the front shroud forward and up to remove. Slide
the rear cover to the rear and rotate it clockwise to
slip over the electric starter button and extension
cord plug located in the left rear corner (Fig. 004).

Primer Button

When depressed the primer button pressurizes the
carburetor bowl. Fuel is forced up the main tube to
the carburetor venturi. This line and button are the
atmospheric vent for the carburetor bowl. If the line
is kinked or the vent hole in the bulb is plugged, the
carburetor may fl ood.
3-2
Fig 004
MVC-900XB
To remove the primer button, pull the primer line off the
stem and compress the tabs. The primer will push out to
the rear (Fig. 005).

Ignition Switch

To remove the ignition switch, pull the wire harness off
the switch terminals. The switch is a snap in type. To
remove the switch, depress the ears on the switch body
(Fig. 006) and push the switch out through the rear of
the shroud. Switch troubleshooting is provided in the
electrical section.
Fig 005
MVC-865XA
Fig 006
MVC-863XA
Power Max Service Manual