Reassembly - Toro Power Max Service Manual

CONTROLS
5. Lift the metal latch pawl off the hex on the cable
lever. Lift out the latch trigger and spring. Note the
orientation of the pawl to the lever for reassembly
(Fig. 023).
6. Rotate the cable until the barrel fi tting slides off the
cable lever (Fig. 024).
4-4
Fig 023
MVC-837X
Fig 024
MVC-554F

Reassembly

1. Begin assembly by dropping the latch spring over
the boss. The straight end of the spring should be
down with the hooked end up (Fig. 025).
2. Slide the latch trigger over the boss until it is fully
seated, making sure that the stop on the trigger
lever is above the stop on the quick lever, as shown.
While holding the trigger lever in place, rotate the
hooked end of the spring until it hooks under the
front edge of the trigger lever as shown (Fig. 026).
A. Latch trigger
Fig 025
MVC-759F
A
Fig 026
MVC-758F
Power Max Service Manual