Control Operation, Replacement & Adjustment; Defl Ector Cable - Toro Power Max Service Manual

Assembly
Reverse the above process for assembly.
Note the spring on the lockout latch. The end with the
slight bend goes behind the lockout latch and the hooked
end goes over the small tab. It is easiest to install the
latch mechanism then hook the end of the spring with a
wire and pull it into place (Fig. 034).
Power Max Service Manual
Fig 034
MVC-176X
CONTROL OPERATION,
REPLACEMENT, AND ADJUSTMENT
Defl ector Cable
1. To remove the defl ector cable, depress the tabs that
retain the cable in the bracket, under the control
panel. Disconnect the Z bend on the end (Fig. 035).
2. Remove the cable clamp and disconnect the cable
end from the defl ector. Reverse this process to
install a new cable (Fig. 036).
CONTROLS
Fig 035
MVC-870X
Fig 036
MVC-882X
4-7