How To Set A System With Groups - Honeywell Galaxy TouchCenter Plus User Manual

How to Set a System with Groups

On systems that have several independent groups (areas), it is possible to perform combination sets and unsets.
Note: Some systems may not have groups, in which case the
To set groups:
ICON
1. Do one of the following:
a) Present a valid Prox tag at the reader for 3 seconds.
b) On the
Home
a valid PIN
and then press
Any faults on the system will be displayed now (see
How to Set the System
2. Press the Timed Set
set status is displayed.
3. Do one of the following:
a) Press any groups you wish set (
Set ), and press the tick icon.
b) Press
Set All
groups message is displayed for a few seconds).
The Exit Time
4. Exit the building while the exit tone is sounding. A
double beep confirms setting completion.
Security (cont'd)
Group List
ACTION
screen, press the icon, enter
Security
(Personal Identification Number) code,
ent .
).
icon. A list of the groups and their
changes to
Unset
Warning – Ready to set all
(the
in seconds begins to countdown.
screen is not displayed.
Notes:

You may have access to some or all of the available groups.

If your user code is accepted, the system displays the groups to
which you have access.
When exit delay time expires, the screen automatically returns to the
Home screen.
To
12
NOTES