To cancel an alarm, fault or tamper:
ICON
1. On the
Home
2. Enter a valid
PIN
code, and then press
The buzzer will be silenced and the cause of the
activation will be displayed.
Note: After an alarm, fault or tamper has occurred the system must be reset in order to be used again.
To reset the system after an alarm, fault or tamper:
ICON
1. Clear the cause of the alarm, fault or tamper. (A call to
your installer may be required)
2. On the
Home
3. Enter a valid
PIN
code, and then press
4. On the keypad, view the alarm, fault or tamper
conditions.
5. Press the
Reset
If the condition has cleared and your PIN has sufficient
authority then the alarm, fault or tamper is reset.
Security (cont'd)
ACTION
screen, press the
icon.
Security
(Personal Identification Number)
ent
.
ACTION
screen, press the
icon.
Security
(Personal Identification Number)
ent
.
icon.
Any alarm, fault or tamper condition that has not been cleared is shown
each time a PIN is entered. When the condition is first activated, you
are alerted by the keypad buzzer.
11
NOTES
NOTES