Dlp-L77 Installing Timing Wires On Ncs 2015 - Cisco NCS 2006 Hardware Installation Manual

DLP-L77 Installing Timing Wires on NCS 2015

Step 2 Tighten the screws of the SCSI connector to a torque value of 4 in-lb (0.45 N-m) using #2 Philips Dynamometric
screwdriver.
Step 3 Bend the cable at an angle of 90° to exit from the left side or the right side (see the figures below ).
Step 4 Return to your originating procedure (NTP).
Figure 201: Installing the Alarm Cable — Left and Right Exit
1
DLP-L77 Installing Timing Wires on NCS 2015
Purpose
Cisco NCS 2000 Series Hardware Installation Guide
352
Alarm cable 2
This task installs the timing cables on the power input
panel.
Connecting and Routing the Cables
Screws