Connecting Power and Ground
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
NTP-L35 Installing the Power and Ground to the NCS 2002 Shelf
ANSI and ETSI:
• #2 Phillips Dynamometric screwdriver
• Medium slot-head screwdriver
• Small slot-head screwdriver
• Screws
• Ground cable 13.3-mm² (#6 AWG) stranded
• Listed pressure dual-holes lugs suitable for #8
AWG copper conductors
• Wire cutters
• Wire strippers
• Crimp tool
• Fuse panel
ANSI only:
• Power cable (from fuse panel to assembly), #8
AWG, copper conductors, 194 degrees F [90
degrees C])
• Wire wrapper
ETSI only:
• Power cable (from fuse panel to power
modules), shipped with the NCS 2002 ETSI
• Two-hole grounding lug, shipped with the NCS
2002 ETSI
• Connect the chassis to the office ground. For
detailed instructions on how to ground the
chassis, refer to the
Grounding Guide for Cisco NCS 2000 Series
Required
Onsite
None
Cisco NCS 2000 Series Hardware Installation Guide
Electrostatic Discharge and
.
77