Connect The Phone To The Cisco Unified Communications Manager - Cisco 8821 Administration Manual

Connect the Phone to the Cisco Unified Communications Manager

b) Press More and select Save.
Step 8
Select Security mode.
Step 9 Select the type of security that the access point requires.
Step 10 Set the required security fields using the following table:
Security Mode
None
WEP
PSK
EAP-FAST
PEAP-GTC
PEAP-MSCHAPV2
EAP-TLS
Step 11 Select 802.11 mode and select the required mode.
The mode determines the frequency. If you set the mode to Auto, the phone can use either the 5 GHz or 2.4
GHz frequency, with 5 GHz as the preferred frequency.
Step 12 Select On call power save and press Select to change the setting.
This field should only be set to Disabled if required for troubleshooting.
Step 13 Press More and select Save.
Step 14 Press Power/End Call
Connect the Phone to the Cisco Unified Communications
Manager
Before You Begin
• You need the IP address of the Cisco Unified Communications Manager TFTP server.
• The phone must be configured in the Cisco Unified Communications Manager
• The phone must be connected to the Wi-Fi network.
Cisco Wireless IP Phone 8821 and 8821-EX Administration Guide for Cisco Unified Communications Manager
68
Configured Field Description
- When the Security mode is set to None, no other fields
are required.
WEP key Enter the 40/104 or 64/128 ASCII or Hex WEP key.
Passphrase Enter the 8-63 ASCII or 64 Hex Passphrase.
User ID Enter the userid.
Password Enter the password
User certificate Select the type of certificate. For more information,
see
.
Configuration on the Phone
Certificates, on page 28.