Charge Your Phone With The Desktop Charger - Cisco 8821 Administration Manual

Charge Your Phone with the Desktop Charger

Charge Your Phone with the Desktop Charger
You can tell when your phone is charging in the charger when the phone LED lights red and a message or
icon displays on the phone screen. When the battery is fully charged, the LED turns off. Your phone can take
up to 3 hours to recharge.
If your phone has a protective case, you don't need to remove the case before you charge the phone in the
desktop charger. You adapt the charger to fit the phone.
When you put the phone into the charger, make sure that you align the charging pins on the bottom of the
phone with the connector in the charger. When the phone is correctly placed in the charger, it is held in place
with magnets. If the LED does not light, then the alignment is not correct.
Do not charge the phone in a hazardous environment.
Caution
Do not charge the phone if it is wet.
Procedure
Step 1 (Optional) Turn the charger so that the back is facing you, put three fingers about 3/4 of the way into the cup,
press in, and lift. The cup should slide out.
Note
Step 2
Place your phone in the charging slot with the screen facing towards you. If your phone is in a case, press the
phone into the charging slot to ensure that the phone connects with the contacts.
Make sure that the LED on the phone lights red. If the LED does not light up, remove the phone and reinsert
it into the charger.
If your phone is in a case, the phone and case will tilt out because of the case.
Step 3 When you remove the phone from the charger, tilt the phone forward and lift it up to disconnect the connecter
from the magnets.
Cisco Wireless IP Phone 8821 and 8821-EX Administration Guide for Cisco Unified Communications Manager
80
You might need to use two hands to remove the cup the first
time.
Accessories