Table 10 - The Basic Display Menus - Honeywell ST 700 User Manual

LCD Contrast »»»»»
Pressure
Percent Output
PV Display
Loop Output
None
X.X
PV Decimal
X.XX
X.XXX
atm, bar
ftH2O @ 68ºF
gf/cm2
inH2O @ 39ºF
inH2O @ 60ºF
inH2O @ 68ºF
inHg @ 0ºC
kgf/cm2, kPa
Pressure Units
mbar,
mmH2O @ 4ºC,
mmH2O @ 68ºF,
mmHg @ 0ºC,
MPa, Pa,
psi
Torr,
mHg @ 0ºC
Zero Correct Do Correct
LRV Correct Do Correct
URV Correct Do Correct
Reset Corrects Do Correct
DAC Zero Trim
Note: Loop must be DAC Zero Trim
removed from
Automatic Control
DAC Span Trim
Note: Loop must be DAC Span Trim
removed from
Automatic Control
Page 28
Table 10 – The
Basic Display Menus
ST 700 SmartLine Pressure Transmitters User's Manual
Adjust the LCD contrast level.
Range from » (1) to »»»»»»»»»
(9)
Default: »»»»»»»(7)
Pressure Units Select Process
Variable (PV) to
%
be shown on the
mA
display from list.
Select the PV decimal resolution to
be shown on selected screen from
list.
Choose appropriate engineering
units from list
Executing this selection corrects the
Zero based on the input pressure
Executing this selection corrects the
LRV based on the input pressure
Executing this selection corrects the
LRV based on the input pressure
Executing this selection Resets the
Zero, LRV, and URV Corrects back
to Factory values
This selection allows the loop zero
output 4mA value to be trimmed.
Note: You must connect a current
meter to the transmitter to monitor
the loop output.
This selection allows the loop span
output 20mA value to be trimmed.
Note: You must connect a current
meter to the transmitter to monitor
the loop output.
Press  to
enter menu
selection
 and  to
select level.
 to enter
Press  to
enter menu
selection
 and  to
select from
list  to enter
Press  to
enter menu
selection
Press  to
initiate action
Press  to
enter menu
selection
 and  to
select
number.
 to enter
and shift to
the next digit
to the right
Revision 8.0