The Display Menu; Table 7 - The Display Menus - Honeywell STT750 SmartLine User Manual

4.2.5. The Display Menu

'#' in "Screen #" indicates the screen numbers 1, 2, 3, 4, 5, 6, 7, 8
LCD Contrast
Rotation Time
Screen Rotate
Select Screen
Screen #
Screen # PV
Screen # Decimal
Screen # Units
(Writable only for
TC/RTD sensor types
only)
Range/Cal Units
(Visible for TC and
RTD sensor type only)
Sensor Type
(Database updates
take 30 seconds to
complete. Do not
interrupt power).
Sensor ID
(Database updates
take 30 seconds to
complete. Do not
interrupt power).
Sensor Wire Type
(Visible for RTD and
Ohm sensor type only)
Sensor Lead Resist
(Visible for RTD and
Ohm sensor type only)
Sensor Bias
Revision 4
Table 7 – The
Adjust the LCD contrast level.
Range from » (1) to »»»»»»»»»
»»»»»
(9)
Default: »»»»»»» (7)
Enabled Select to enable or disable the
Disabled automatic rotation of Screens
1 through 8
Select Screen to configure.
Select to enable or disable the
Enabled/Disabled
screen for display and configuration
Loop PV
Select the Process Variable (PV)
CJ Temperature
that will be shown on the screen.
Sensor
Sensor Resistance is only available
Resistance
for RTDs and will read 0 for
Loop Output
thermocouples
Percent Output
None
Select the PV decimal resolution to
X.X
be shown on selected screen from
X.XX
list.
X.XXX
Choose appropriate engineering
°C, °F,°R, K
units from list
°C, °F, °R, K Select the ranging and calibration
temperature units
mV, TC, RTD,
Ohm
Select Sensor Type.
Select Sensor ID for Input selected
Sensor Identifier
Sensor Type (Input selection).
2-Wire, 3-Wire, 4- Select the number of lead wires for
Wire RTD and Ohm sensors.
Sensor lead wire resistance value.
####.##
(only if RTD type is 2 wire)
####.## Bias on the measured value
STT750 Temperature Transmitter User's Manual
Display Menus
Press ↵ to
enter menu
selection
↑ and ↓ to
select entry.
↵ to enter
Page 23