Safety Certification Information; Transmitter Adjustments; Display Options -Standard Display; Optional Integrated Two-Button Assembly (Standard Display) - Honeywell ST 700 User Manual

10.4 Safety Certification Information

An "approvals" name plate is located on the bottom of the Electronics Assembly; see Figure 42 exact
location. The approvals name plate contains information and service marks that disclose the
Transmitter compliance information.
of this document for safety certification requirements and details.
See section 0

10.5 Transmitter Adjustments

Zero and Span adjustments are possible in ST 700 Basic Transmitter with the optional external 2-
button and integrated two-button assemblies. See Figure 42 for the external 2-button assembly.
You can also use the Honeywell MC Toolkit or other third-party hand-held configurator to make
adjustments to the ST 700 Basic Transmitter. Alternately, certain adjustments can be made through
the Experion or Universal Station, if the Transmitter is digitally integrated with a Honeywell
Experion or TPS system.
10.6 Display Options –Standard Display
Table 29 – ST 700 Basic Transmitter - Available Display Characteristics
Standard Display 




10.7 Optional Integrated two-Button Assembly (Standard Display)

The Standard Display does not support all the transmitter configuration parameters and has limited
features. The optional Integrated Two-Button Assembly for the Standard Display provides the
following features and capabilities:

Menu and enter key functionality.

With the menu-driven display:
o Comprehensive on-screen menu for navigation.
o Transmitter configuration: enter LRV, enter URV and Loop Test.
o Transmitter calibration
o Display configuration (contrast only)
o Set zero and span parameters.
Page 74
o o
360 rotation in 90 Increments
2 lines, 8 characters
Standard units of measurement: Pa, KPa, MPa, KGcm2, TORR, ATM, inH2O,
mH2O, bar, mbar, inHg, FTH2O, mmH2O, MMHG, Flow Units (DP models
only) ,PSI , cmH2O and mH2O
Diagnostic messaging
If you are using the optional external 2-button assembly with the Standard
Display then you can perform all the above operations without removing
external glass cap using the external buttons
ST 700 SmartLine Pressure Transmitters User's Manual
Revision 8.0