Configuration Guide; Table 2 - Available Display Characteristics; Table 3 - Basic Display Configuration - Honeywell STT750 Quick Start Installation Manual

CONFIGURATION GUIDE

Table 3 shows the transmitter Basic Display Configuration.
Use these tables to configure the transmitter.

Basic
Display





Note: ''#' indicates selected screen number 1 - 8
LCD Contrast
Rotation Time
Screen Rotate
Select Screen
Screen #
Screen # PV
Screen # Decimal
Table 2 – Available Display Characteristics
Suitable for basic process needs
o
360 rotation in 90
8 configurable screens
2 lines,16 characters
Standard units of measurement: °F, °C, °R, K, Ω, mV & %
Diagnostic messaging
Table 3 – Basic Display Configuration
»»»»»
Enabled
Disabled
1 through 8
Enabled/Disabled
Loop PV
CJ
Temperature
Sensor
Resistance
Loop Output
Percent Output
None
X.X
X.XX
X.XXX
Quick Start Installation Guide
SmartLine Temperature Transmitter
o
increments
Adjust the LCD contrast
level.
Range from » (1) to
»»»»»»»»» (9)
Default: »»»»»»» (7)
Select to enable or
disable the automatic
rotation of Screens
Select Screen to
configure.
Select to enable or
disable the screen for
display and configuration
Select the Process
Variable (PV) that will be
shown on the screen.
Sensor Resistance is only
available for RTDs and
Ohm sensor types and
will read 0 for
thermocouples
Select the PV decimal
resolution to be shown on
selected screen from list.
Press ↵ to
enter
menu
selection
↑ and ↓ to
select
entry.
↵ to enter
15