Connecting The Ethernet Management Interface - Cisco D9040 User And Service Manual

Connecting the Ethernet Management Interface

The Ethernet Interface
The RJ-45 interface for 10/100 BASE-T Ethernet is intended for PNC management.
Hint: If you experience problems with the 10 BASE-T Ethernet it is recommended
that you change it to a 100 BASE-T connection.
Note: You must set up the IP address, the default gateway and the subnet mask to
match the network connection. This is done through the front panel menu. For
further information, see Front Panel Setup, page 1-3.
Pin Allocation, Ethernet Connector
The table shows the Ethernet connector and the pin allocation (MDI interface)
Connector
Informative Notes
Proper cables are required for reliable Ethernet operation; to run over a maximum
segment length of 100 m the cable has to comply with the EIA/TIA Category 5 wire
specifications.
To Connect the Ethernet Interface
1. Connect a crossed RJ-45 cable between the Ethernet connector on the D9040
Encoder and the Ethernet port of your PC.
Note: You need a crossover cable if you want to connect the Ethernet interface of
the D9040 Encoder directly to another Ethernet device without using a hub or
switch.
You need to set up the IP address on both the D9040 Encoder (via the front panel
display). For information on setting up the IP address via the front panel, see Front
Panel Setup, page 1-3.
4020024 Rev C
Pin
1
2
3
4
5
1 8
6
00-052
7
8
Pin allocation
Tx+
Tx-
Rx+
Not connected
Not connected
Rx-
Not connected
Not connected
Installation
:
3-15