Table of Contents
Advertisement
Connecting the Units
Electrical Connection
Proceed as follows to connect the units:
Reference
AC Power
Input
Composite Input ASI Output 1 +2 Alarm
1. Connect the video input signal to the SDI IN and COMPOSITE IN connector.
For further information, see Connecting the Video and Reference Signal
Inputs, page 3-7.
2. If relevant, connect the reference input signal to the REF IN connector.
For further information, see To Connect the Reference Input, page 3-7.
3. Connect the audio input signals for channels 1 and 2 to the DIGITAL AUDIO IN
(2 BNC connectors) or ANALOG AUDIO IN 1+2.
Use a high-quality shielded balanced audio cable for the analog inputs or a
single-ended cable for the digital inputs. For further information, see
Connecting the Audio Inputs, page 3-8.
4. Connect the statmux interface connector of each of the D9040 Encoders to one of
the 16 statmux channel connectors of the Regulus Controller.
Use a one-to-one RS-232 cable. For further information, see Connecting the
Statmux Interface, page 3-13.
5. If relevant, connect the audio input signals for channels 3 and 4 to the terminal
block connector labelled ANA/DIG AUDIO IN 3 & 4. For further information,
see Connecting the Audio Inputs, page 3-8.
6. If relevant, connect the cable from the external alarm system to the ALARM
connector.
For further information, see Connecting an External Alarm System, page 3-14.
4020024 Rev C
Chapter 1
Quick Setup - Read Me First!
ASI Monitor
Management
Quick Setup - Read Me First!
Unused
Cue
Tone
SDI In
Statmux
Unused
Analog Audio
Contact
Closure
In, 1 + 2
Analog/Digital
Digital
Audio In, 3 + 4
Audio In,
1 + 2
04-032
1-1
Advertisement
Table of Contents
