Cisco D9040 User And Service Manual page 68

System Menu,
Continued
IP, Management, Gateway
Parameters:
Description:
Software Version
Parameters:
Description:
Module Info, Main
Parameters:
Description:
Module Info, H.264
Parameters:
Description:
Module Info, Adv. Video Input
Parameters:
Description:
Module Info, Dual Audio
Parameters:
Description:
1)The audio module has no software part number and will show N/A in the software part
number field.
4-8
<0 to 255>.<0 to 255>.<0 to 255>.<0 to 255>
The default gateway of the management interface to D9040
Encoder. The D9040 Encoder uses this gateway to route IP traffic
across the network. Setup similar to IP, Management, IP Address,
page 4-7, above.
Note: The default gateway setting is not affected by the Default
command.
Hint: The default gateway 0.0.0.0 means that no gateway is used.
N/A
The software version of the system controller.
N/A
The hardware and the software part numbers of the main board.
N/A
The hardware and the software part numbers of the H.264 (VE6)
board.
N/A
The hardware and the software part numbers of the Advanced
Video Input module.
N/A
The hardware part number
audio module contains two stereo channels or 4 mono channels.
Front Panel Operation
1)
of the optional audio module. The
4020024 Rev C